FluxTone Model 3

"V-30"

Factory Original "Celestion Vintage 30" cone, spider and voice coil

This is a very musical speaker, with a lot of complex overtones.

FluxTone side speaker attenuator for guitar amplifiers
FluxTone speaker attenuator for guitar amplifiers
click to enlarge
FluxTone Model 3

50 Watts rms, 8 or 16 Ohms, 12 inch, 15 pounds Much has been written about this Famous cone and voice. I do not think I can add much to that litany of praise, other than to say it is a very "Hearty Speaker" with a lot of class.

Demonstration
MicrophoneBeyer M 160 @ 18 inches (on axis)
Pre-AmpGrace Design M 501
GuitarMexican Strat (Dimed)

Includes VMT “Speaker Control” and Wires

VMT Speaker Control
Guituar Amp Attenuator Power Supply
VMT Speaker Control
click to enlarge

$1500 (list) + $ Shipping in lower 48 states.

(If you're outside of this area, please Contact Us before ordering.)

Qty:

Technical Information

Guitar amp speaker attenuator for guitar amplifiers

Celestion model (Vintage30) 60 watt 8 Ohm

This is the voice of an original Celestion Vintage 30. These images are relative.

Speaker attenuator for guitar amplifiers

FluxTone Model 3 50 watt 8 Ohm

This is the voice of a FluxTone Model 3. As you can see the pattern is nearly the same.

NOTE

Frequencies from a guitar speaker below 60hz are influenced more by the cabinet structure than the speaker, and frequencies above 6khz too high for any 12 inch cone to reproduce in a way that can be heard over the normal sounds coming from that speaker (that's why there are tweeters). That being factual, we say "ignore" the data on the graphs below 60hz and above 6khz because they have no bearing on this test.
General Specifications
Magnet Type (Alnico Topology)Copper & Iron
Magnet weight11.5 Lbs.
Frequency Range70-5000Hz
DC Resistance (Re)7.3 & 12.9
Sensitivity100dB
Chassis TypePressed steel
Voice coil diameter1.75", 44.5mm
Voice coil materialRound copper
Resonance frequency (fs)75Hz